RC-Vintage

Code : Tout sélectionner

I managed to get my hands on two non Turnigy receivers that work with the Turnigy 9X transmitter:

HK TR6A V2 - 6 channel
HK GT2R - 3 channel

Both receivers binds just fine with the Turnigy 9X transmitter. I have not had a chance to range test them yet, but as far as I can understand the TR6A should give the same range as the 9X8C v2 receiver that come with the transmitter and the GT2R is a short range receiver that will probably only be suitable for park flyers.

The procedure I followed to bind these was as follows:
1. RX & TX Off
2. Insert Bind plug into the BAT (TR6A) or VCC (GT2R) port (yeah, did not use the bind port, confusing...)
3. Insert your battery pack/speed control into the last channel (nearest to the bind plug).
4. Light in receiver should flash slowly
5. While holding the "Bind Range Test" button on the back of the 9X transmitter (on the module), switch on the 9X transmitter.
6. Light on receiver should turn solid, indicating successful bind (nearly instantly in my case). At this point you can leave the bind button.
7. Switch off receiver, unplug the bind plug and plug in your controller and servos as per usual.